# DiMarzio series/parallel (Dual Sound) wiring

Canonical page: https://guitarwiring.app/wiring-guides/dimarzio/series-parallel

One switch, two humbucking sounds: full power in series, cleaner and brighter in parallel. Here is the lug-by-lug wiring from DiMarzio's sheet.

Applies to: DiMarzio four-conductor pickups with side-by-side coils, on a DPDT mini-switch (DiMarzio EP1106) or a push-pull pot (EP1200PP or EP1201PP). Lug numbers are the ones printed on DiMarzio's drawing.

## Two sounds, both hum-cancelling

DiMarzio calls this wiring Dual Sound. In series the two coils work one after the other, for maximum power. In parallel they work side by side: the sheet describes that sound as slightly less powerful, with more highs and cleaner overall.

Parallel is not the same as a coil split. A split turns a coil off and the pickup stops cancelling hum. Dual Sound wiring cancels hum in both positions.



## Parallel without a switch

If you only ever want the parallel sound, no switch is needed. Join red and white: that is the hot connection. Join green and black: that is the ground connection. The bare wire goes to ground as always.



Wiring | Hot | Joined and taped | Ground
--- | --- | --- | ---
Series (standard) | Red | Black + white | Green, bare
Parallel | Red + white | Nothing | Green + black, bare

## Wire the Dual Sound switch

DiMarzio numbers the six lugs of the DPDT switch: 3, 2 and 1 along one row, 6, 5 and 4 along the other, so that 1 sits beside 4. All four pickup wires go to the switch. Lug 6 stays empty.

Do not skip the jumper between lugs 3 and 5. Without it the series position has no connection between the coils and the pickup is silent.

- Solder a short jumper between lugs 3 and 5.
- Solder white to lug 2 and black to lug 5.
- Solder red to lug 1, with a wire from lug 1 to wherever the old pickup's hot wire went.
- Solder green to lug 4, with a wire from lug 4 to ground.
- Solder the bare wire to ground.

Switch lug | What connects there
--- | ---
1 | Red wire, and the wire to hot output
2 | White wire
3 | Jumper to lug 5
4 | Green wire, and the wire to ground
5 | Black wire, and the jumper from lug 3
6 | Nothing

## If the pickup needs reversed phase

The sheet gives the change in one line: use lug 4 as the hot output and connect lug 1 to ground. The bare wire is still soldered to ground.



## Three sounds: series, single coil, parallel

Wire the same diagram on a three-position on-on-on DPDT mini-switch (DiMarzio EP1108) and you get a third sound. The two outside positions are series and parallel. The centre position is single coil.



## See it in a complete guitar

This DiMarzio diagram puts series/parallel switching on the push-pull tone pots of a Les Paul style guitar. The six lugs under each pot are the switch described above.



Sources: DiMarzio 4-Conductor Pickup Instructions. https://www.dimarzio.com/support/wiring-diagrams

Independent explanation by Tinkercaster; not endorsed by DiMarzio.
