A complete workbench for guitar wiring.
Tinkercaster brings guitar wiring diagrams, component references and a 3D workbench together. Design your circuit, understand every connection, and follow the build step by step at the bench.
- checked wiring diagrams
- 333checked wiring diagrams
- components with terminal-level specs
- 655components with terminal-level specs
- pickup layouts, from single coils to HSSH
- 17pickup layouts, from single coils to HSSH
- switch types, blades, toggles and push-pulls
- 14switch types, blades, toggles and push-pulls
Why it exists
Guitar wiring has always been a small, closed world: diagrams scattered across manufacturer PDFs and old forum threads, specs you have to piece together, and a lot of people who never pick up the iron because one wrong wire feels like it could ruin the guitar.
The mission is to open that up. Put every common layout, pickup and switch in one place, draw it the same way every time, check it, and let you try it on a board before you touch the real thing.
If you have never soldered, start with a course. If you have done it for years, go straight to the diagrams.
From a diagram to a finished harness
Most wiring help stops at the diagram, and you are on your own at the bench. Tinkercaster stays with you the whole way, from the first idea to the last solder joint.
Design it
Start from one of 333 checked diagrams or a blank board, and wire real parts from the catalog, terminal by terminal.
Check it on screen
Step through switch positions, trace every pickup connection and read nominal resistance with the virtual DC meter.
Ask AI Luthier
Stuck on a connection? Ask about the board in front of you. Luthier can propose changes for you to review and apply.
Build it step by step
At the bench, follow one highlighted connection at a time, see where to put your meter probes and save each reading as you go.
The editor cannot inspect a physical solder joint, measure your actual components or guarantee that a harness will fit inside a guitar.
The company behind Tinkercaster
Tinkercaster is operated by Programmer Network in Copenhagen, Denmark, and was founded by Aleksandar Grbic, a musician and software developer.
It was created to make guitar electronics easier to understand, with diagrams, parts and practical build guidance in one connected workspace. Meet the founder, or reach support from the contact page.
- Operated by
- Programmer Network
- Based in
- Copenhagen, Denmark
- Company register
- CVR 46158768
- [email protected]
Join the community
Wire your next guitar here.
Start drawing without an account, and save and share your boards with a free one. Pro adds guided builds and AI Luthier.