Skip to content
Tinkercaster

DiMarzio wiring

Model P with one volume and one tone

One P-Bass · No switch · One volume · One tone

DiMarzio Model P DP122BK through a 500K custom-taper volume, a 250K custom-taper tone and a .033 µF capacitor, to a Switchcraft two-conductor jack.

Viewed from the back of the controls, as you solder them.

Model P with one volume and one toneModel P with one volume and one tone: One P-Bass · No switch · One volume · One tone. Original Tinkercaster drawing with labelled terminals.Model P500k250k33nFredgreenblackwhitelug1lug2lug3lug1lug2lug3abtipsleevegroundModel PVolume 500K custom taperTone 250K custom taper.033µFOutput jackBridge ground

Open the interactive diagram to zoom, move components and try the switches.

Parts and values

In the drawingValuePart
Model PSource: Model P DP122BK—DiMarzio Model P DP122Example part
Volume 500K custom taperSource: Volume 500K custom taper pot (EP1201)500kCTS 500k Audio PotExample part
Tone 250K custom taperSource: Tone 250K custom taper pot (EP1200)250kCTS 250k Audio PotExample part
.033µFSource: .033µF capacitor (EP1033)33nFOrange Drop .033µFExample part
Output jackSource: Switchcraft output jack, 2-conductor (EP1301)—Switchcraft #11Example part
Bridge groundSource: TO BRIDGE GROUND—Bridge ground wireGeneric

Every pickup is the maker's own. “As specified” means the sheet names that part. “Example part” means the sheet names no model: the pickup shown is one of the maker's with the same leads, and any pot, cap or switch with the same value and lugs will do. “Generic” is a plain part such as a ground wire. “Not on the sheet; stand-in” means the sheet prints no value for that part, so the value shown is the usual one, not the maker's.

Connections

In soldering order: grounds first, then the switch, the pickups and the signal path.

#FromToHow
1Pickup groundVolume casingTo a pot casing
2Volume ground lugVolume casingShort black link.To a pot casing
3.033µF capacitorTone casingTo a pot casing
4Tone casingVolume casingTo a pot casing
5Tone casingJack sleeveWire
6TO BRIDGE GROUNDJack sleeveShield or ground
7Pickup hot (red)Volume input lugWirered
8Model P blackModel P whiteSeries link: soldered together and taped off, as the maker's sheet shows.Joined and insulatedblack
9Volume middle lugJack tipWire
10Volume input lugTone middle lugWire
11Tone bottom lug.033µF capacitorWire

What it does

Engine result: Model P (both coils).

Checked with the Tinkercaster wiring engine against the switching the source describes.

  • The P-Bass is drawn as the Model P; its split-coil and hum-cancelling construction is not modelled.
  • The source's custom-taper pots are not reproduced: both pots are simulated with a linear track, so settings between the knob ends are approximate.
  • Tone capacitor value matches the printed .033µF.
  • Pickup resistance is not specified, so no numeric meter readings are given.

Before you solder

Ticks are kept in this browser only, as a reminder. They are not a check of your joints. New to soldering? Read the soldering cheat sheet .

Check before plugging in

  • With both pots up, the meter across the jack should read the pickup resistance.
  • The jack sleeve should read continuity to the volume casing, the tone casing and the bridge ground wire.

Measure across the output jack with a multimeter on its resistance range. No exact readings are given where the source does not specify the pickups.