Skip to content
Tinkercaster

Tonerider wiring

One humbucker and one volume

One humbucker · One volume

A four-conductor humbucker in series through one 500kA volume to a mono jack. Tonerider draws it for all its four-conductor AC and H series humbuckers.

Viewed from the back of the controls, as you solder them.

One humbucker and one volumeOne humbucker and one volume: One humbucker · One volume. Original Tinkercaster drawing with labelled terminals.Humbucker500kredblackwhitegreenbarelug1lug2lug3tipsleevegroundHumbuckerVolume 500kAOutput jackBridge ground

Open the interactive diagram to zoom, move components and try the switches.

Parts and values

In the drawingValuePart
Humbucker—Tonerider Alnico 2 ClassicExample partSame wiring for Tonerider Alnico 4 Classic, Tonerider Rocksong
Volume 500kA500kCTS 500k Audio PotExample part
Output jackSource: Output Jack—Switchcraft #11Example part
Bridge groundSource: Ground Wire from Bridge—Bridge ground wireGeneric

Every pickup is the maker's own. “As specified” means the sheet names that part. “Example part” means the sheet names no model: the pickup shown is one of the maker's with the same leads, and any pot, cap or switch with the same value and lugs will do. “Generic” is a plain part such as a ground wire. “Not on the sheet; stand-in” means the sheet prints no value for that part, so the value shown is the usual one, not the maker's.

Connections

In soldering order: grounds first, then the switch, the pickups and the signal path.

#FromToHow
1Bridge groundVolume casingShield or ground
2Humbucker greenVolume casingTo a pot casinggreen
3Humbucker bare shieldVolume casingBare shield wire.Shield or groundbare
4Volume right lugVolume casingTo a pot casing
5Volume casingJack sleeveGround from volume to jack.To a pot casing
6Humbucker blackHumbucker whiteSoldered together and insulated.Joined and insulatedblack
7Humbucker redVolume left lug (input)Wirered
8Volume middle lugJack tipSignal output to jack.Wire

What it does

Engine result: Humbucker (both coils).

Checked with the Tinkercaster wiring engine against the switching the source describes.

  • Hum cancelling and phase follow the pickups' lead colours and coil polarity as Tonerider publishes them; nothing here is measured.
  • Pickup resistance is not specified, so no numeric meter readings are given.

Before you solder

Ticks are kept in this browser only, as a reminder. They are not a check of your joints. New to soldering? Read the soldering cheat sheet .

Check before plugging in

  • With the volume up, the meter across the jack should read the humbucker's resistance.
  • The taped black–white joint should read about one coil's resistance to ground, roughly half the pickup's total (a few kΩ): not open, and not zero.

Measure across the output jack with a multimeter on its resistance range. No exact readings are given where the source does not specify the pickups.