Skip to content
Tinkercaster

Tonerider wiring

One P90 with one volume

One P90 · No switch · One volume · No tone

A single P90 straight into a 500kA volume and out to a mono jack. Tonerider draws it for all its P90 pickups.

Viewed from the back of the controls, as you solder them.

One P90 with one volumeOne P90 with one volume: One P90 · No switch · One volume · No tone. Original Tinkercaster drawing with labelled terminals.P90500kwhiteblackbarelug1lug2lug3tipsleevegroundP90Volume 500kAOutput JackGround Wire from Bridge

Open the interactive diagram to zoom, move components and try the switches.

Parts and values

In the drawingValuePart
P90Source: P90 (white, black, bare shield)—Tonerider Hot 90Example part
Volume 500kA500kCTS 500k Audio PotExample part
Output Jack—Switchcraft #11Example part
Ground Wire from Bridge—Bridge ground wireGeneric

Every pickup is the maker's own. “As specified” means the sheet names that part. “Example part” means the sheet names no model: the pickup shown is one of the maker's with the same leads, and any pot, cap or switch with the same value and lugs will do. “Generic” is a plain part such as a ground wire. “Not on the sheet; stand-in” means the sheet prints no value for that part, so the value shown is the usual one, not the maker's.

Connections

In soldering order: grounds first, then the switch, the pickups and the signal path.

#FromToHow
1P90 black (with Bare Shield Wire)Volume casingThe source draws the black lead and the Bare Shield Wire to the same casing spot; one wire stands for both.To a pot casingblack
2Volume right lugVolume casingShort black link.To a pot casing
3Volume casingJack sleeveWire
4Ground Wire from BridgeVolume casingShield or ground
5P90 bare shieldVolume casingShield or groundbare
6P90 whiteVolume left lug (input)Wirewhite
7Volume middle lugJack tipWire

What it does

Engine result: P90.

Checked with the Tinkercaster wiring engine against the switching the source describes.

  • The P90 is drawn as the Tonerider Hot 90, from its catalog leads.
  • Pickup resistance is not specified, so no numeric meter readings are given.

Before you solder

Ticks are kept in this browser only, as a reminder. They are not a check of your joints. New to soldering? Read the soldering cheat sheet .

Check before plugging in

  • With the volume up, the meter across the jack should read the P90's resistance.
  • The jack sleeve should read continuity to the volume casing and the bridge ground wire.

Measure across the output jack with a multimeter on its resistance range. No exact readings are given where the source does not specify the pickups.