Skip to content
Tinkercaster

DiMarzio wiring

One humbucker with one volume

One humbucker · No switch · One volume · No tone

DiMarzio's single bridge humbucker with one 500K custom-taper volume and a Switchcraft two-conductor output jack. The black and white leads are joined and insulated.

Viewed from the back of the controls, as you solder them.

One humbucker with one volumeOne humbucker with one volume: One humbucker · No switch · One volume · No tone. Original Tinkercaster drawing with labelled terminals.Bridge pickup500kredgreenblackwhitebarelug1lug2lug3tipsleevegroundBridge pickupVolume 500K custom taperOutput JackBridge Ground

Open the interactive diagram to zoom, move components and try the switches.

Parts and values

In the drawingValuePart
Bridge pickupSource: Bridge pickup (BARE, GREEN, RED, BLACK, WHITE)—Super Distortion DP100Example partSame wiring for DiMarzio Dual Sound DP101, DiMarzio Super 2 DP104, DiMarzio DLX Plus Bridge DP154, DiMarzio Norton DP160, DiMarzio Steve's Special DP161, DiMarzio D Sonic DP207
Volume 500K custom taperSource: Volume 500K custom taper pot (EP1201)500kCTS 500k Audio PotExample part
Output JackSource: Switchcraft output jack, 2-conductor (EP1301)—Switchcraft #11Example part
Bridge GroundSource: TO BRIDGE GROUND—Bridge ground wireGeneric

Every pickup is the maker's own. “As specified” means the sheet names that part. “Example part” means the sheet names no model: the pickup shown is one of the maker's with the same leads, and any pot, cap or switch with the same value and lugs will do. “Generic” is a plain part such as a ground wire. “Not on the sheet; stand-in” means the sheet prints no value for that part, so the value shown is the usual one, not the maker's.

Understand this wiring

  • DiMarzio humbucker wire colors

    Red is hot, black and white join each other, green and bare go to ground. See why, and what changes when you reverse the phase.

All DiMarzio wiring guides →

Connections

In soldering order: grounds first, then the switch, the pickups and the signal path.

#FromToHow
1TO BRIDGE GROUNDJack sleeveShield or groundblack
2Pickup BAREVolume casingShield or groundbare
3Pickup GREENVolume casingTo a pot casinggreen
4Volume casingVolume top lugTo a pot casingblack
5Volume top lugJack sleeveThe jack sleeve carries a ground symbol.Wireblack
6Pickup BLACKPickup WHITEJoined and insulated.Joined and insulatedblack
7Pickup REDVolume bottom lug (input)Wirered
8Volume middle lugJack tipWire

What it does

Engine result: Bridge pickup (both coils).

Checked with the Tinkercaster wiring engine against the switching the source describes.

  • The source's 500K custom taper is not reproduced: the pot is simulated with a linear track.
  • Hum cancelling and phase follow the pickups' lead colours and coil polarity as DiMarzio publishes them; nothing here is measured.
  • Pickup resistance is not specified, so no numeric meter readings are given.

Before you solder

Ticks are kept in this browser only, as a reminder. They are not a check of your joints. New to soldering? Read the soldering cheat sheet .

Check before plugging in

  • With the volume up, the meter across the jack should read the humbucker's resistance.
  • The taped black–white joint should read about one coil's resistance to ground, roughly half the pickup's total (a few kΩ): not open, and not zero.

Measure across the output jack with a multimeter on its resistance range. No exact readings are given where the source does not specify the pickups.