Skip to content
Tinkercaster

DiMarzio · The wiring reference

DiMarzio phase reversal and the phase switch

Out of phase is the hollow, quieter sound of two pickups working against each other. Fix it by swapping red and green, or put it on a switch.

Applies to

DiMarzio four-conductor pickups with side-by-side coils or blades, in a guitar with two or more pickups. Phase means nothing for one pickup played alone.

What out of phase sounds like

DiMarzio's FAQ describes it as significant signal cancellation across the guitar's whole frequency range: a hollow sound and a drop in output. The drop is most obvious with a dead-clean amp. An overdriven amp compresses, which hides it.

Two pickups are never completely in or out of phase, because they sit under different parts of the string. How far apart they are, and which models they are, changes how much cancels.

Fix an unwanted out-of-phase sound

If two pickups sound weak and thin together and you did not want that, reverse the phase of one of them. On a DiMarzio pickup that means swapping red and green: green becomes hot, red goes to ground. Black and white stay joined and the bare wire stays on ground.

If the pickup is wired in parallel, the sheet gives the matching change: the joined green and black become hot, and the joined red and white go to ground.

Put phase on a switch

A phase switch lets you choose the hollow sound on purpose. The sheet sets three rules. It only works in an instrument with two or more pickups. The effect only happens when both pickups are on, and is most obvious when they are at about the same volume. Only one pickup is wired to the switch, and it makes no audible difference which one.

The switch is a DPDT: a mini-switch (DiMarzio EP1106) or a push-pull pot (EP1200PP or EP1201PP). Red and green from the pickup go to the switch, and the switch sends one of them to hot and the other to ground. Flipping it swaps them. The bare wire never goes through the switch.

Phase switch plus coil split

DiMarzio shows the two switches together and points out a side effect. With two pickups on, the phase switch does its normal job. With this pickup on alone and split, the phase switch chooses which of the two coils is turned off, a subtle change in tone.

Do not combine the two on HS, Area and Virtual Vintage models. The sheet says one position turns on only the bottom coil, producing almost no signal.

Single coils: order it reversed

A true single coil has no spare wires to swap for hum cancelling with its neighbour. DiMarzio's FAQ says all of its true single-coil pickups are available with reversed polarity and connections at no additional charge.

Source and interpretation

Original explanation by Tinkercaster, based on DiMarzio 4-Conductor Pickup Instructions and the DiMarzio Product FAQ. The guide describes the stated configuration; it does not establish compatibility with every pickup or switch.

Not affiliated with or endorsed by DiMarzio. Refer to your exact pickup's instructions when a detail differs.

Put it in a complete circuit

Use a complete wiring diagram to see how the pickup, controls and output connect. Our public diagrams are free to view and explore.

Browse DiMarzio diagrams →

Understand this wiring

All DiMarzio wiring guides →